Hairdo Flirty Waves Warm Blond With Brown Root

How to use

 

1. Remove the net from the wig.

2. Shake the wig lightly to separate the fibers and give it back its natural volume. 3. If your hair is long, pin it flat at the nape of the neck for a soft silhouette under the wig.

Tip: You can use the nylon cap to cover your head and keep your hair still and more composed.

4. Place the front of the wig at your natural frontline and pull the back of the wig to place it on the nape of the neck.

5. Adjust the wig, if necessary, by sliding it from front to back and side to side. The semi-rigid side flaps must be positioned at the same height. Use your fingers or a ponytail comb to hide any leftover hair under the wig.

6. Create the style you want by simply using your fingers, a comb or a brush. The adjustable velcro © straps, placed in the lower back of the wig, allow you to adjust the size of the cap.

Advice

 

Remove any knots with your fingers or a comb. Do not brush. Add a tablespoon of treated hair shampoo to a basin of cold water. Soak for 5 minutes and rinse in cold water. Don't rub. Be sure to remove all the shampoo as the residue could damage the fiber. Blot with a towel. Don't squeeze. Do not brush or comb the fiber when wet as it could be damaged. Do not put the wet wig on a head. Hang and let it dry naturally. The tru2life © fiber is heat resistant and can withstand a maximum temperature of 180 ° C.

IMPORTANT: When straightening using a straightener, take strands as thin as possible and move them from the root to the tips. Continue with a smooth motion until the hair is straightened to your liking. When using a wave iron, take small strands, roll them around the iron flat (not twisting). Leave the strand around the iron for about 7-10 seconds. Then slide the fiber out of the iron gently and use a hair clip until the fiber cools and the curl is fixed. All Hairdo © wigs are equipped with adjustable velcro © straps, placed inside the net with which it is possible to adjust the size of the wig.

Material

 

Product made with Tru2Life © fiber: heat resistant synthetic hair.

 

Maintenance

Made of heat resistant Tru2life® fiber, it can be shaped with normal thermal styling tools.

Wash the wig or HairDo ™ extension after wearing them 3-4 times. Follow these short steps and the product will be as good as new, giving you even more glamor and style:

Close all clips and carefully undo the knots using your fingers, a wide-toothed comb or a flat brush.

Important: always untangle HairDo ™ by first untangling the tips and then moving up towards the hairline.

Fill the sink or basin with cold water and 1-2 tablespoons of shampoo.

Dip the Extension or HairDo ™ wig gently into the water and let it soak for 5 minutes, DO NOT RUB.

Rinse thoroughly with cold water. The shampoo must be removed completely otherwise the shampoo residues could damage the fiber.

After shampooing, pat the product gently with a towel without pulling or twisting.

Spray a no-rinse spray conditioner and gently comb the lengths with your fingers, a wide-toothed comb or a flat brush without pulling on the fiber to maintain a natural shine and aid styling.

Leave to dry naturally on a clean towel.